Adafruit Si5351A Clock Generator with STEMMA QT - 8KHz to 160MHz breakout Consider bed adhesion - PETG

Consider bed adhesion - PETG can stick too well to glass beds (some use glue stick or hairspray as a barrier layer)

Default I2C address: 0x36 (range 0x36 to 0x3D with address jumpers)

Compatible with MakeCode via custom blocks and MicroPython with available example code

align the side with the silver latch bit (which is slightly wider than 0

RTC support

Adafruit Si5351A Clock Generator with STEMMA QT - 8KHz to 160MHz breakout Consider bed adhesion - PETGNever hunt around for another crystal again, with the Adafruit Si5351A clock generator breakout! This I2C controlled chip has a precision 25MHz crystal reference, internal PLLs and dividers, allowing it to generate frequencies from less than 8 kHz up to over 150 MHz. It features three independent outputs that can each be set to different frequencies, with a 3Vpp signal available through a breadboard header or an optional edge launch SMA connector for